• Home
  • Box One Carbon 22.2mm Handlebars

Box One Carbon 22.2mm Handlebars



USD $‎99.99 to USD $‎119.99
SKU: BX-HB17C


USD $‎99.99 to USD $‎119.99

Please select options before adding to cart

Ultra-lightweight Box One™ Carbon BMX Handlebars are made using advanced carbon fiber technology. Designed for smaller BMX racers, they feature a unique profile that increases stiffness and strength, while keeping the weight extremely low. Box One™ Carbon Handlebars are designed for BMX racing only. They should be installed by a professional bicycle mechanic and inspected for damage after crashing or suffering an impact.

Please note, the maximum recommended rider weight for these bars is 100 pounds.

3" Mini4.5" Junior6" Expert
Clamp (Ø)22.2mm22.2mm22.2mm
Material3K Carbon Fiber3K Carbon Fiber3K Carbon Fiber
Sweep6° back, 2° up6° back, 2° up6° back, 3° up
Weight162 grams / 5.7 ounces182 grams / 6.4 ounces285 grams / 10.1 ounces
Width21.5 inches23.6 inches26 inches
BARCLAMP (Ø)HEX LAB MINIBOX ONE CENTER CLAMPBOX ONE FRONT LOADBOX ONE TOP LOADDELTABOX TWO FRONT LOADBOX TWO TOP LOADBOX TWO FRONT LOAD 1 INCHBOX TWO TOP LOAD 1 INCHBOX TWO CENTER CLAMP 1 INCH
Hex Lab Carbon OS28.6mm
Box One Cromo Triple Taper31.8mm
Box One Cromo Triple Taper V31.8mm
Box One Cromo Triple Taper Flat31.8mm
Box One Alloy Triple Taper31.8mm
Box One Carbon 22.222.2mm
Box Two Alloy Triple Taper22.2mm
PRODUCT CARE
  • Carbon fiber products should ONLY be installed by a trained professional bicycle mechanic.
  • Carbon fiber products are designed to be lightweight and pass stringent EN standards, but they may not be suitable for all rider sizes and riding styles.
  • Check your carbon fiber parts regularly to ensure there are no deep scratches or gouges, chips, cracks, loose carbon fibers or any other surface imperfections.
  • Damaged carbon fiber can fail suddenly and without warning, causing serious injury or death.
  • Carbon fiber can conceal damage from an impact or crash. If you suspect that your carbon fiber part has been crashed or impacted, stop riding immediately and have a professional bicycle mechanic inspect the part.
  • Use only carbon friendly brake levers, grips and stems on handlebars/forks. Be sure to remove any burrs and sharp edges from any clamping surfaces that will be in contact with the carbon fiber. These sharp edges can damage and compromise the strength of the carbon product.
  • Carbon handlebars should be installed with carbon paste. The paste increases surface friction and allows for lower torque settings. When tightening the stem face plate, do so in a criss-cross pattern until the specified torque setting for the handlebar is reached to achieve a balanced installation. NOTE: Do not use the torque setting recommended for the stem. A carbon handlebar’s maximum torque is 7 Nm -- tightening a stem in excess of 7Nm can crush the carbon fiber tubing.
  • If narrowing a carbon handlebar, this must be performed by a professional mechanic using a carbon specific hacksaw.
  • Do not install bar ends on carbon handlebars.
  • BMX carbon forks and handlebars are for BMX racing ONLY and not for dirt jumping or any other use that is not for their intended purpose.
  • Carbon fiber products should not be cleaned with harsh chemicals, use only soapy water.
  • Always wear a helmet and wear the appropriate safety wear for the conditions that you ride in.
  • Prior to riding, always give your bicycle a safety inspection.